Coolsculpting vs Sculpture: Which Treatment is Good for Me?

CoolSculpting and SculpSure are two non-invasive body contouring treatments that can help reduce stubborn fat in areas that are typically hard to sculpt. The main difference between the two procedures is the type of lipolysis technology they use to dissolve and break up fat tissues. SculpSure uses laser heat technology to melt away fat cells while CoolSculpting freezes them away using its advanced cryolipolysis (or fat freezing) procedure. Both treatments are non-invasive, and there is no downtime with either, so you can get on with your day as usual after both CoolSculpting and SculpSure. The choice between the two procedures depends on the individual's preference and the area of the body they want to target.

What is the Difference Between SculpSure and CoolSculpting?

CoolSculpting and SculpSure are both non-surgical body contouring procedures that can help you achieve a slimmer, more sculpted appearance. However, there are some key differences between the two procedures that may make one a better fit for you than the other.

What are the Treatment Areas of Coolsculpting and SculpSure?

CoolSculpting and SculpSure are both non-surgical fat reduction procedures that use different technologies to target and destroy fat cells. The treatment areas of CoolSculpting and SculpSure are as follows:

CoolSculpting

• Abdomen

• Flanks

• Love handles

• Thighs

• Back

• Chin

• Neck

• Bra fat

• Underarm fat

• Banana roll

• Upper arms

SculpSure

• Abdomen

• Flanks

• Back

What is the Temperature Difference Between Coolsculpting and SculpSure?

CoolSculpting and SculpSure use different temperature ranges to destroy fat cells in the treatment areas.

CoolSculpting uses precisely controlled freezing to freeze and kill fat cells at a temperature of around -11°C to -12°C.

SculpSure, on the other hand, uses laser panels to heat the fat cells below the skin and destroy their integrity at a temperature of around 42°C to 47°C.

What is the Success Rate of the Coolsculpting and SculpSure?

The success rate of CoolSculpting and SculpSure is generally considered to be high. However, it is important to note that the results of these procedures vary from person to person.

A study published in the journal "Plastic and Reconstructive Surgery" found that CoolSculpting was able to reduce fat by an average of 22% in the abdomen and 24% in the flanks. The study also found that the results of CoolSculpting were maintained for at least 2 years.

Another study, published in the journal "Dermatologic Surgery", found that SculpSure was able to reduce fat by an average of 24% in the abdomen and 23% in the flanks. The study also found that the results of SculpSure were maintained for at least 6 months.

It is important to note that these studies were conducted on small groups of people and the results may not be representative of everyone who undergoes CoolSculpting or SculpSure. The success of these procedures also depends on a number of factors, such as the individual's body type, the amount of fat in the targeted area, and the number of treatments.

What is the Treatment Duration Between CoolSculpting and SculpSure?

The treatment duration for both CoolSculpting and SculpSure varies depending on the area being treated. A typical CoolSculpting treatment lasts between 25 minutes to 1 hour. On the other hand, SculpSure sessions can last for up to 25 minutes, and patients can see significant results in that time. The exact time needed for each treatment will depend on how large of an area you are treating. Both treatments are non-invasive, and there is no downtime with either, so you can get on with your day as usual after both CoolSculpting and SculpSure.

Are there any Aftercare Tips for SculpSure and CoolSculpting Treatments?

Aftercare tips for SculpSure and CoolSculpting treatments include:

For CoolSculpting:

Massage the treated area post-treatment to encourage healthy healing and optimal results.

Apply warm compresses to the treated area.

Wear a compression garment.

Avoid direct sun or tanning for one week before treatment.

For SculpSure:

Gently massage the treatment areas for five to ten minutes twice a day.

Drink lots of water.

Avoid direct sun or tanning for one week before treatment.

What are the Side Effects of Coolsculpting and SculpSure?

Both CoolSculpting and SculpSure are non-invasive treatments that have been shown to be extremely safe and have been approved by the FDA for their safety and efficacy. However, as with any medical procedure, there are potential side effects to consider.

Common side effects of CoolSculpting include:

Redness

Firmness

Pinching sensation

Minor swelling

Tenderness

Bruising

Stinging

Tingling

Numbness

Skin sensitivity

Mild to moderate pain

Muscle cramping

Itchiness, especially a few days after the procedure

Diarrhea, as dead fat cells are removed from the body

A feeling of fullness in the throat

Additional Rare Complications that may occur after CoolSculpting include:

Pain that starts several days after the treatment and usually resolves when numbness goes away, or after about a month.

Scarring or changes to skin color.

Reduced movement or response of the tongue following procedures involving the neck or chin.

Lower lip muscle weakness following procedures involving the neck or chin.

Reduced saliva production and dry mouth following procedures involving the chin or neck.

Common side effects of SculpSure include:

Slight bruising and swelling in the treatment area for a few hours after the treatment

Minor redness or soreness in the area treated

Who are Good Candidates for the Coolsculpting and SculpSure?

The ideal patients for CoolSculpting and SculpSure are those who are in relatively good physical shape but want to shift stubborn areas of fat. Both treatments are non-invasive, meaning there is no downtime, and they are suitable for people who are in relatively good physical shape but want to shift stubborn areas of fat. However, it's important to note that individual results may vary, and the success rate of either treatment depends on the individual's unique physiology.

Ideal candidates for SculpSure:

Individuals with a BMI under 30.5.

Those who want to target multiple areas at once.

Those who prefer a more comfortable treatment experience.

Ideal candidates for CoolSculpting:

Those with a higher-than-average BMI, including those physically considered as overweight.

Those who want to sculpt and re-contour up to 13 different areas of the body.

Those who prefer a treatment that uses extreme cold to freeze fat cells.

Is Coolsculpting Better Than SculpSure?

The choice between CoolSculpting and SculpSure depends on the individual's preference and the area of the body they want to target. Both treatments are non-invasive, meaning there is no downtime, and they are suitable for people who are in relatively good physical shape but want to shift stubborn areas of fat.

Some people may prefer CoolSculpting because it uses extreme cold to freeze fat cells, while others may prefer SculpSure because it uses laser technology to heat and melt them. CoolSculpting works better on patients with more fat, while SculpSure's laser application allows treatment for those with tighter body types. SculpSure can target multiple areas, including thin layers of fat, whereas CoolSculpting is a slightly different technology that suctions skin.

‍